Procure PC01 Cyanoacrylate Adhesive

Product Overview

  • • Surface insensitive cyanoacrylate adhesive for difficult to bond materials
  • • Fast cure speed of 3 to 20 seconds on most materials
  • • Medium viscosity at 100cPs
  • • Available in 10g, 20g, 50g and 500g - for other options, please contact us

Product Information

 

Procure PC01 High Performance Cyanoacrylate Adhesive Banner Image.

Procure PC01 High Performance Cyanoacrylate Adhesive

PC01 a Surface Insensitive Industrial Grade CA

Procure PC01 cyanoacrylate adhesive is a high performance, fast curing, medium viscosity cyanoacrylate adhesive. Its surface insensitive properties mean it will bond almost any substrate, including most plastics, rubbers and metals to themselves and each other. Ideal for bonding porous or permeable substrates such as leather, fabric, wood and paper.

 

Directions For Use

 

1. Make sure the surfaces to be bonded are clean and dry.
2. Dispense adhesive to one surface only. Apply only enough to leave a thin film after compression.
3. Press parts together and hold firmly for a few seconds. (Maximum strength is achieved in 24 hours).
4. Procure activator can be used to cure exposed adhesive outside of the joint, to help prevent blooming.
5. Wipe off excess adhesive from the top of the container and recap.

 

Cyanoacrylate Adhesive Activation

 

Activators PC750, PC780 and PC790 may be used with cyanoacrylates where a faster cure speed is required. Fixture times of less than 2 seconds can be obtained with most cyanoacrylates. Testing on the parts to measure the effect is recommended.

 

Instant Adhesive Priming

 

Procure PC77 primer is recommended for use on low energy plastic surfaces such as polyethylene, polypropylene, PTFE and thermoplastic rubber materials.

Apply to one surface only. PC77 also has a mild activating effect which may accelerate the cure speed of cyanoacrylate adhesives.

 

Debonding Cyanoacrylate Adhesives (CA) 

 

Cured cyanoacrylate may be removed from most substrates, and parts disassembled, with Procure PC68 debonder – however, ensure to test compatibility of the substrate with PC68 first as this may dissolve some plastics.

It is not possible to fully remove cyanoacrylate from fabrics.

 

Adhesive Dispensing

 

Factors that affect dispensing are pressure, time and needle size. As a general reference low viscosity liquid would need a small needle diameter and less pressure, a high viscosity liquid would need a larger needle diameter (tapered recommended) with higher pressure to dispense. Information on the recommended hand dispensing tip can be found in the Technical Data Sheet (TDS).

 

Procure PC01: General Information

Further information about Procure PC01 Industrial CA

 

For information on safe handling of Procure PC01 cyanoacrylate adhesive consult the Safety Data Sheet (SDS).