Adhesive Supplier - Home
- Products
- Private Label Adhesives
- Procure® Cyanoacrylate Products
- Mitrelock® Professional Wood Adhesives
- Lockfast® Engineering Adhesives
- Procure®UV Light Curing Adhesives
- React General Purpose Adhesives
- ProGlue™ Model Glue
- Bison® Adhesives
- Crestabond Structural Adhesives
- Adhesive Ancillaries & Support Products
- Technical
- About Us
- Services
- Contact
Product Information
Procure PC95 Cyanoacrylate Adhesive
PC95 a Surface Insensitive Industrial Grade CA
Procure PC95 is a high performance, fast curing, low viscosity cyanoacrylate. Formulated as a wicking grade to allow the adhesive to flow into close fitting, pre-assembled parts. PC95 is suitable for bonding a wide variety of materials but it performs particularly well on difficult to bond materials such as rubbers and plastics.
PC95 is a suitable replacement for Loctite 495.
Directions For Use of Cyanoacrylate Adhesive (CA)
1. Ensure surfaces for bonding are clean and dry.
2. Dispense adhesive to one surface only. Apply only enough to leave a thin film after compression.
3. Press parts together and hold firmly for a few seconds. (Maximum strength achieved after 24 hours).
4. Use Procure activator to cure exposed adhesive outside of the joint, to minimise blooming.
5. Wipe off excess adhesive from the top of the container and recap.
Activator for Cyanoacrylate Adhesives
To accelerate cure speed, use Cyanoacrylate Activators PC750, PC780 and PC790. Fixture times of under 2 seconds can be attained with most cyanoacrylates but firstly test parts to gauge the effect.
Primer for Instant Adhesive
Applied to low energy surfaces, Procure PC77 primer enables a stronger bond on materials like polyethylene, polypropylene, PTFE and thermoplastic rubber materials.
PC77 has a mild activating effect, meaning potential for accelerated cure speed of cyanoacrylate adhesives.
Debonding Cyanoacrylate Adhesives (CA)
Remove cured cyanoacrylate from most substrates and parts disassembled with Procure PC68 de-bonder. Test substrate compatibility first, certain plastics may dissolve.
It is not possible to fully remove cyanoacrylate from fabrics.
Cyanoacrylates and Adhesive Dispensing
Factors that affect dispensing are pressure, time and needle size. As a general reference low viscosity liquid would need a small needle diameter and less pressure, a high viscosity liquid would need a larger needle diameter (tapered recommended) with higher pressure to dispense. Refer to the Technical Data Sheet (TDS) for information on the recommended hand dispensing tip.
Procure PC95: General Information
Procure PC95 Industrial CA Handling
For information on safe handling of Procure PC95 cyanoacrylate adhesive consult the Safety Data Sheet (SDS).