REACT GP Medium Adhesive

Product Overview

  • • General Purpose Adhesive
  • • Medium viscosity at 100 cPs
  • • Recommended for use on close-fitting parts
  • • Available in 20g, 50g, 500g

Product Information

REACT GP Medium Adhesive

REACT GP Medium Adhesive is a medium viscosity cyanoacrylate adhesive. Suitable for close fitting substrates. Materials that can be bonded include plastics, rubbers, metals, wood and other common substrates, which can be bonded to themselves and each other.

 

Directions For Use

 

1. Make sure the surfaces to be bonded are clean and dry.
2. Dispense adhesive to one surface only. Apply only enough to leave a thin film after compression.
3. Press parts together and hold firmly for a few seconds. (Maximum strength is achieved in 24 hours).
4. Procure activator can be used to cure exposed adhesive outside of the joint, to help prevent blooming.
5. Wipe off excess adhesive from the top of the container and recap.

 

Activation

 

REACT GP low stain activator may be used with REACT GP adhesives where a faster cure speed is required. Fixture times of less than 2 seconds can be obtained with most cyanoacrylates. Testing on the parts to measure the effect is recommended.

 

Priming

 

Procure PC77 primer is recommended for use on low energy plastic surfaces such as polyethylene, polypropylene, PTFE and thermoplastic rubber materials.

Apply to one surface only. PC77 also has a mild activating effect which may accelerate the cure speed of cyanoacrylate adhesives.

 

Debonding

 

Cured cyanoacrylate may be removed from most substrates, and parts disassembled, with Procure PC68 debonder – however, ensure to test compatibility of the substrate with PC68 first as this may dissolve some plastics.

It is not possible to fully remove cyanoacrylate from fabrics.

 

Dispensing

 

Factors that affect dispensing are pressure, time and needle size. As a general reference low viscosity liquid would need a small needle diameter and less pressure, a high viscosity liquid would need a larger needle diameter (tapered recommended) with higher pressure to dispense.

General Information

 

For information on safe handling of REACT GP Medium Adhesive consult the Safety Data Sheet (SDS).