Lockfast G10 Gasket Maker

Lockfast G10 Gasket Maker is a red, heat and chemical resistant gasket maker. It is designed for the bonding and sealing of gaskets where high temperature resistance is needed.  Ideal for sealing close-fitting joints between flanges and fixed metal faces. Can flex with minor movement from the flange.

G10 is used as a form-in-place gasket for applications on pumps, compressors, axle covers and transmission housings. G10 is also UV fluorescent, making it easily identifiable when carrying out inspections.

Directions For Use

1. For optimum performance surfaces should be clean and free of grease.

2. If the material is an inactive metal consider using activator.

3. Shake the product thoroughly before use. Apply several drops to parts to be sealed.

4. Assemble as required.

5. To prevent the clogging of the nozzle, do not let the tip touch metal surface during application.

Fixture Time vs. Substrate

There may be a difference in fixture speed and strength based on the substrate. As opposed to passive materials such as stainless steel or zinc dichromate, anaerobic adhesives will reach full strength more rapidly with active materials such as mild steel and brass.

For more information on strength of bond and cure time, please see the Lockfast gasketing and pipe sealants technical information sheet.

Disassembly and Clean-up

Remove with standard hand tools. In circumstances where hand tools do not work, use localised heat, disassemble while hot. To remove cured product use a combination of solvent and abrasion such as a wire brush.

General Information

For information on safe handling of Lockfast G10 Gasket Maker consult the Safety Data Sheet (SDS).

Available in 50ml and 250ml tubes – contact us for more information.