Mitrelock Wood Mitre Adhesive, a strong wood glue kit that dramatically reduces assembly time on natural materials such as MDF, hard and soft wood, paper, cardboard, and leather. The combination of Mitrelocks Adhesive and Activator gives the user a reliable command cure. Mitrelock locks in seconds using three simple steps.
The Mitrelock wood mitre adhesive kit has a fast fixture speed and creates a strong lasting bond.
Mitrelock is a two-part, instant bond, wood mitre adhesive kit. The kit contains a 50g adhesive and a 200ml aerosol activator.
The adhesive is a medium to high viscosity ethyl cyanoacrylate, which is designed specifically for use on close fitting mitre joints. In contrast to other cyanoacrylate adhesives, this adhesive works well on MDF, softwoods, hardwoods, paper, cardboard, and leather. Due to its high viscosity, the adhesive also has excellent gap filling properties on vertical, rough, and irregular surfaces.
The activator is used to dramatically reduce assembly time on natural materials by not only accelerating the typical fixture time of the adhesive, but also giving the user a reliable command cure.
(The free pencil is a limited introductory offer whilst stock lasts.)
By replacing traditional fittings such as screws and nails, Mitrelock offers a more efficient and reliable bonding solution than alternatives such as PVA or hot-melt adhesives.
In addition to being quick and clean to use, Mitrelock works with a wide variety of substrates to lock close fitting mitre joints.
An essential toolbox accessory, the Mitrelock wood mitre adhesive kit locks in seconds!
• Kitchen and bedroom fitting.
• Construction and joinery, especially cornice and mitre joints.
• MDF trim manufacture.
• Laminate floor beading.
• General woodworking applications.
• Picture framing.
Spray activator on to one surface and allow to dry. (The activator can be applied to one surface in advance if required. Please speak to a member of our team for more information.)
Apply adhesive to the other surface. (Less is more, Mitrelock adhesive should be applied sparingly as over application may result in slower fixture speeds, and it may lower the overall bond strength.)
Assemble parts. Locks in seconds.
For further technical information or if you have a different question please contact us.